Publishing House SB RAS:

Publishing House SB RAS:

Address of the Publishing House SB RAS:
Morskoy pr. 2, 630090 Novosibirsk, Russia



Advanced Search

Combustion, Explosion and Shock Waves

2017 year, number 2

Numerical Study of the Effect of Burnout on the Ignition Characteristics of Polymer under Local Heating

D. O. Glushkov, G. V. Kuznetsov, P. A. Strizhak
Tomsk Polytechnic University, Tomsk, 634050 Russia
Keywords: горючий полимер, разогретая частица, выгорание, зажигание, combustible polymer, heated particle, burnout, ignition

Abstract

This paper presents a numerical study of the effect of burnout on the ignition delay of a typical thermoplastic polymer (polymethylmethacrylate) by a metal particle heated to a high temperature. The initial temperature of the power source was varied from 960-1150 K. Three ignition modes of the polymer are distinguished according to the temperature of the heat source, ignition delay, and the position of the ignition zone in the vicinity of the hot particle. It is found that under local heating conditions, the burnout of the heated area of the surface layer affects insignificantly (by less than 5%) the increase in the basic characteristics of the process - the ignition delay. At the time of initiation of the combustion, the degree of thermal degradation of the polymer (degree of conversion) does not reach even 15% in the section corresponding to the maximum heat flux from the heat source. It is shown that the ignition delay increases more significantly when accounting for the temperature dependence of the thermal properties of polymethylmethacrylate than when accounting for the burnout factor. The induction period is increased by 15- 25% due to an increase in the polymer storage capacity and heat transfer rate from the heated the area of the surface layer deeper into the material.