On the Choice of Forming Modes and Estimation of Residual Service Life by Kinetic Equations with the Scalar Damage Parameter
I. A. Banshchikova
Lavrent'ev Institute for Hydrodynamics, Siberian Branch, Russian Academy of Sciences, Novosibirsk, 630090, Russia
Keywords: конструкционные сплавы, разупрочнение, упрочнение, повреждаемость, рациональные режимы ползучести, растяжение, structural alloys, softening, hardening, damage, rational creep, tension
Abstract
The kinetic equations of creep are used to compare damage accumulation in rods under tension in two forming modes: at constant stresses and at constant strain rates corresponding to strain rates in steady-state creep for the same stresses. It is found that from the point of view of increasing the residual service life at the production stage, forming to the required strain value with given kinematics is preferable to forming under the action of constant stresses for materials on whose strain-time charts for = const, the fracture strain decreases monotonically with increasing stress. Forming at constant stress is preferred for materials on whose strain-time charts for = const, the fracture strain increases monotonically with increasing stress. Calculation results for several alloys are presented.
|
