LABORATORY MODELING AND MEASUREMENT OF THE ELECTRICAL RESISTIVITY OF HYDRATE-BEARING SAND SAMPLES
M.E. Permyakov1, N.A. Manchenko1, A.D. Duchkov1, A.Yu. Manakov2, A.N. Drobchik1, A.K. Manshtein1
1A.A. Trofimuk Institute of Petroleum Geology and Geophysics, Siberian Branch of the Russian Academy of Sciences, pr. Akademika Koptyuga 3, Novosibirsk, 630090, Russia
2A.V. Nikolaev Institute of Inorganic Chemistry, Siberian Branch of the Russian Academy of Sciences, pr. Akademika Lavrentieva 3, Novosibirsk, 630090, Russia
Keywords: Tetrahydrofuran, tetrahydrofuran hydrates, modeling of hydrate-bearing samples, electrical resistivity
Abstract
We describe a setup for modeling hydrate-bearing rock samples and measuring their electrical resistivity at different pressures and temperatures using an AMNB cylindrical four-electrode probe. Methods for modeling hydrate-bearing rock samples and measuring their resistivity are considered. The setup was used in a series of experiments to measure the resistivity of sand samples containing water, ice, or tetrahydrofuran (THF) hydrate. It is shown that when the rock pores contain hydrates and a partially unfrozen aqueous solution of NaCl and THF, the electrical resistivity is determined by the high resistivity of the solution and increases with the formation of hydrate. The presence of THF hydrate in the experimental samples increased their resistivity by 180-320 Ohm·m at a temperature of about 0 °C. After the formation of hydrate and freezing of residual water, the resistivity of the sample is stabilized at 70-80 kOhm·m at a temperature of -15 °C.
|
